10
Installation Steps
2.7 Step 7 Fit the roof dome
Snap the dome onto the dome ring using the 4 snap closures.
Ensure that all four
connecting points are properly engaged.
Important:
Fit the dome with the LightTracker flex on the north side (facing south).
Tip:
If you want to remove the dome again, insert the end of a wide screwdriver into the
opening of the snap fasteners and pry it off one by one from below.
2.8 Step 8 Attach the brush seal
Stick the brush seal strip around the outside of the bottom tube assembly or uppermost
extension tube, just below the top of the tube as shown below. Using the entire sealing strip,
wrap the strip around the tube keeping the rings tightly together as shown.
Note:
if additional extension tubes are being used this operation must be performed around
the top of the uppermost extension tube.
Once the angle is correctly set, carefully apply tape to the outside of the tube over the tube
seams and around the angle.
2
1
