3/29
INSTRUCTIONS— GAS AIR HEATER -
MINIGAZ Eco
MH Eco, MC Eco, MV Eco– NT09004I-GB – 29/11/2017
1-1-GENERAL RECOMMENDATIONS
These devices must only be installed in sufficiently ventilated buildings, except for devices equipped with airtight
connection.
The good operation of the air heater depends upon correct installation and start up.
Any non-respect of these rules would immediately imply the manufacturer’s discharge.
The installation and maintenance must be made according the regulation and good engineering practices in force, by skilled
personnel.
DO NOT INSTALL ANY GAS AIR HEATER IN:
-
Premises with explosion risks,
-
Premises with chlorinated combinations fumes,
-
Premises with high combustible dust content,
-
Highly humid premises (electrical danger),
-
Domestic premises.
It is of the responsibility of the installer, after having checked that the assembly respects the prescriptions of these
instructions:
1°) To inform the user:
-
that he cannot modify himself the devices design nor the installation implementation ;
Any modification (exchange,
setting back….) of safety components or parts, that influence the device output or quality of combustion, systematically
implies the EC mark withdrawal.
-
that it is indispensable to have the recommended cleaning and maintenance operations made.
One yearly
preventive maintenance operation is compulsory.
2°) To give the user these instructions:
SOLARONICS Chauffage, with the EC marking notifying organization, reserves the right to update these instructions. Only the
instructions provided with the device can be considered as contractual. Do carefully keep them close to the device.
1-1 - Devices description - Operation
The Minigaz Evolution Eco suspended gas air heater is an independent warm air generator, operating with natural gas or propane ;
it is conform to the European Directive 2009/142 that applies to gas devices.
It is a «direct» gas heating system ; it produces and emits heat without intermediary heat transfer fluid.
For the whole range described in these instructions, the combustion products exhaust ,outside the premises, is made by an
extractor. The combustion air is sucked in the inside or outside premises. These devices can be connected with vertical or ho rizontal
balanced-flue terminal or shaft outlet.
The Minigaz Evolution Eco suspended gas air heaters run with the various gas mentioned on their rating-plates according to the
European Directive
1.2. Use instructions
-
For this device operation and maintenance, please read the instructions.
-
Have at least one maintenance operation per year , by skilled personnel. The maintenance operations frequency depends
upon the environment where the appliance is installed. A regular inspection must be made specially in dusty premises.
-
Check regularly that there is no distortion of the device, the chimney or the gas connections.
-
Check regularly that the air openings of the premises and around the device are not clogged.
-
Make sure that the warm air can normally circulate within the premises, and that there is no obstruction at suction (fan side)
nor in front of the supply air terminal device (open grid).
-
The control box should be subjected to one electrical cut per 24 hours at least
1.3. Operation
-
On heat request, the burner ignites thanks to the ignition electrode. The fan starts and the warm air is blown within the
premises. On reaching the set point temperature, the burner goes out. The fan goes on operating during about 1 minute, till the
residual heat escapes from the heat exchanger