53
en
Optimise plant capacity
Select “Activated” to optimise the plant output. The plant output will
be optimised on the basis of the internal consumption and/or the feed
rate.
A precondition for this is a measurement of the internal consumption
and/or the feed rate.
Maximum plant output
Enter the maximum output of your plant in the input field.
Fig. 50: Configuration of the input signals of the MaxRemote
You have the possibility to configure the following parameters of the input signals of the
MaxRemote:
■
■
Status
The MaxWeb XPN has 8 digital inputs (IN1 to IN8). Up to 256 input signal configura-
tions with the corresponding target capacities are therefore possible.
■
■
Active
Mark the corresponding checkbox of the status which shall be active.
■
■
IN1 ... IN8
If the checkbox is activated, the high-level signal is used on the selected input. If the
checkbox is deactivated, the low-level signal will be used.
■
■
Effective power reduction -
Enter the effective power proportion in % of nominal power, to which the plant shall
be limited.
■
■
Idle power
When the checkbox is selected, the plant will generate constant idle power. Enter
the value of the idle power in % of nominal power in the adjacent entry field.
■
■
cos(phi)
If this checkbox is selected, the PV plant generates idle power according to the field
value and the current effective power. Enter the value for cos(phi) in the adjacent
entry field.