Solaris Mozart user manual version 2.0 122216
- 4 -
•
Ensure fixture is connected to proper voltage, and that line voltage is not higher than that stated on the
fixture.
•
Make sure there are no flammable materials close to the unit while operating.
•
Always disconnect from the power source before servicing or fuse replacement. Always use the fuse
specified in this manual..
•
Always use a safety cable when hanging fixture overhead.
•
Maximum ambient temperature (Ta) is 40°C (104°F). Do not operate fixture at temperatures above this
rating.
•
In the event of a serious operating problem, stop using the unit immediately. Repairs must be carried
out by trained, authroized personnel. Conact the nearest authorized technical assistance center. Only
OEM spare parts should be used.
•
Do not connect the device to a dimmer pack.
•
Make sure power cord is never crimped or damaged.
•
Never disconnect power cord by pulling or tugging on the cord.
•
Avoid direct eye exposure to the light source during operation.
Caution! There are no user serviceable parts inside the unit. Do not open the housing or attempt
any repairs yourself. In the unlikely event your unit may require service, please contact your
distributor.
F
USE
R
EPLACEMENT
The Mozart 10-way PSU uses a 6A, 250V, slow-blow, 5x20mm (0.2x0.8 in.) fuse. Mozart fixtures have no
fuse. To replace fuse:
1. With a screwdriver turn the fuse cap counter-clockwise to remove fuse cap with fuse.
2. Replace fuse attached to fuse cap.
3. Reinsert fuse cap with new fuse and tighten clockwise.
M
OUNTING
/R
IGGING
–
MZ10
PSU
10-
WAY
,
M
INI
E
NCLOSURE
Orientation
The Mozart MZ10 PSU 10-way may be mounted on truss or pipe, in any position, using the yoke supplied
with the unit. Always make sure there is adequate room for ventilation.
Rigging
– Always consult a certified rigging engineer before suspending any fixture
overhead!
Use ProBurger
®
couplers or equivalent C- or O-type clamps for attaching to truss. After
establishing the desired position, retighten both knobs.
•
Always use safety cables!
•
When selecting installation location, consider routine maintenance.
•
Never mount Mini enclosure where it will be exposed to moisture, high humidity,
extreme temperatures, or restricted ventilation.
Disconnect the power cord before replacing a
fuse and always replace with the same type fuse.
