6
.
Load Head Assembly by inserting hose into post.
.
Insert Head Assembly into post.
.
Control knob should be above decal on post.
.
Attach Head Assembly to post, and loosely install four
small bolts.
.
Tighten bolts securely.
(For models with Entire Reflector , skip to Step 8
Step 7 – Install Reflector
WARNING
Remove protective cover before assemble.
Note: If necessary for proper alignment of reflector
sections, loose each screw prior to further assembly and
retighten after sections are aligned.
.
Slide
two
Reflector
Panels together.
.
Insert
one
Small
Screw.
.
Slide one Small Flat Washer over threaded end of
screw and screw on Cap Nut loosely.
.
Slide Reflector Plate
onto Reflector Panels.
.
Insert
one
Small
Screw.
.
Slide one Small Flat
Washer over threaded
end
of
screw
and
screw
on
Cap
Nut
loosely.
.
Repeat procedure to complete the assembly of all four
sections.
.
Fully tighten all of the screws in the rolled edge.
9 Req’d Small Screw s
9 Req’d Cap Nuts
9 Req’d Small Flat Washers
Step 6 – Attach Head Assembly to Post
.
Screw off 4 small bolts.
Head Assembly
4 Req’d Small Bolts
