8. For the switch/router side, use a pre-crimped cable or use a crimper to prepare an
RJ45 communication connector: Insert the eight wires into the RJ45 connector in the
same order as above (Figure 2).
9. Connect the cable RJ45 connector to the RJ45 port of the Ethernet switch or router.
You can connect more than one Smart EV Charger to the same switch/router or to
different switches/routers, as needed. Each Smart EV Charger sends its monitored
data independently to the SolarEdge monitoring platform.
10. The Smart EV Charger is configured by default to LAN.
a. Turn ON the AC to the Smart EV Charger by turning ON the circuit breaker on
the main distribution panel.
WARNING!
ELECTRICAL SHOCK HAZARD. Do not touch uninsulated wires when the
SMI cover is removed.
AVERTISSEMENT!
RISQUE D’ÉLECTROCUTION, ne touchez pas les fils non isolés lorsque le
couvercle de Smart EV Charger est retiré.
b. Configure the connection with SetApp. Refer to Processional Installer -
Configuring and Using Smart EV Charger with SetApp on page 44.
11. Verify the connection with SetApp. Refer to
Verifying the Connection to the
Monitoring Platform on page 43.
Smart EV Charger Installation MAN-01-00657-1.0
41
Creating an Ethernet (LAN) Connection