Included Hardware (continued)
Attaching Hinge to Bottom of Sections 1 and 2 – Figure 1a
Step 1. Lay sections one and two next to each other on a soft material (i.e. carpet) with the lamps
facing down, and with the male and female power cords aligned. Section one contains the timer and
main power cord. Section 2 has the short, inter-connecting power cords on both sides.
Step 2. Thread nuts “H” onto the levelers “E” then thread the leveler shafts into the end cap holes “3”
as shown in figure 1a. so that they protrude about 2 inches. Snug the nuts against the end caps. If
necessary, use an adjustable wrench on the levelers at the base of the threaded portion. DO NOT
OVER-TIGHTEN! BE CAREFUL NOT TO STRIP THE THREADS!
Step 3. During this step, make sure that the inter-connecting power cords are securely connected. Do
not pinch the cords between the rails of the two different sections. Have one person at the top end of
the unit, and another person at the bottom end. Both people need to raise the units in the center where
they meet in order to insert the guide bolts of hinge “A” into the “1” holes of the end caps at the
bottom end of the unit. The person at the top end of the unit can hold the two units up in position,
while the person at the bottom end threads bolts “D” through hinge “A” into the “2” holes of the end
caps. Use the supplied allen wrench to tighten these bolts. DO NOT OVER-TIGHTEN! Continue
supporting the two sections through the next step.
