Acrylic Removal
Warning. Disconnect booth from electrical power before servicing.
Important Note: If you are removing the acrylic from the door section, you must first remove the inner
door handle with a Phillips screwdriver. There are two screws that attach the handle to the rail.
Step 1. Stand inside the booth. Using a small, flathead screwdriver, insert the flat head into the top
end of the black trim strip that holds the side of the acrylic. Pry outward slowly to grasp edge of strip
and continue to pull away from unit until it is completely removed. Repeat procedure for second trim
strip.
Repeat step 1 as necessary for the acrylics on the other two sections of the booth
Step 2. With the flathead screwdriver, pry the acrylic up and over the lip in the booth rail. Begin by
grasping the long edges of the acrylic which are now exposed. Step 3. Standing in front of the booth, grasp
the long exposed edge of the acrylic and carefully slide it toward you until it is removed. BE CAREFUL –
the edges of the acrylic may be sharp.
Acrylic Re-installation
Step 1. Seat the acrylic into the lip of the top and bottom end caps.
Step 2. Evenly slide it back into place by pushing from the front side while simultaneously grasping the
opposite edge of the acrylic to support it away from the lamps and reflectors.
Step 3. Replace the trim strips starting at the bottom. Take one end of the black acrylic trim and press
firmly onto the aluminum frame pushing into the opening. The longer flat edge of the trim must be against
the top of the acrylic.
Step 4. Place the palm of your hand on the trim, and apply pressure along the edge until the trim is firmly
in place.
Step 5. The door handle and/or hanging handles will now need to be replaced.
Lamp Removal & Re-installation
Solar Storm Lamps are rated up to 1000 hours of use. You may elect to change lamps sooner.
Step 1. After removing the acrylic, grasp a lamp at one end and at middle. Turn the lamp a
quarter turn. The lamp may then be gently removed from its holder.
Step 2. Hold lamp with brand name label facing toward the acrylic and to the top side of the booth.
To install the lamp, insert the pins located on the ends of the lamp into the slots on top of the lamp
holder and turn the lamp a quarter turn to hold in place. Make sure that the writing on the lamp faces
the acrylic.
For lamp replacement, refer to “Lamp Cleaning” section to follow. Lamps used longer than 1000
hours have lost their tanning power even though they will continue to light.
