Pressing and holding the Up button will cause the display to count up. Pressing and holding the Down
button will cause the display to count down. Once the count reaches 100, the center period will flash rapidly.
This is an indication that you are over 99. For example, if the display shows a .2 with the period flashing, this
is address 102. The highest the display will count up is 255.
3) Press the Up or Down button until the desired address is displayed.
When setting the address remember 3 rules:
A) Set each T- Max® 005 to a unique address.
B) Do not set any address to 00.
C) Do not set any address over 100.
4) Once the desired address is displayed, press and release the Start/Stop button. The “.1” will appear on the
display. Nothing will flash.
5) To exit, press and hold both the Up and Down buttons together until the period goes away.
2.2.2 Setting Delay time.
1) Press and hold the Start/Stop and Up buttons simultaneously on the TMax® 005 until a “.1” appears on the
display. Release the buttons.
2) Press the Up Button until a “.3” is displayed.
3) Press and release the Start/Stop button.
A number will appear on the display and be flashing. A period will be illuminated in the center of the
display. This is the current delay time.
4) Press the Up or Down Button until the desired delay time is displayed. The highest delay time that can be
set on the T- Max® 3A is 10 minutes. If you want no delay time, set the display to 0. If you set the Delay Time
to 0, the session time will start immediately after the Start/Stop button is pressed.
5) Press the Start/Stop button. The “.3” will appear on the display. Nothing will be flashing.
6) To exit, press and hold both the Up and Down buttons together until the period goes away.
3. Using the T-Max® 005 as a Stand Alone Timer
3.1 Starting A Session
1) Press the Up or Down Button on the T-Mx® 005 until the desired session time is displayed. If the display
shows a 0, and you want to go directly to the maximum time, press the down button once.
2) Press and release the Start/Stop button to start the session.
If a delay other than 0 is entered, the delay will count down. A period on the lower right corner of the
display will flash rapidly. When the session starts, the period will flash at a once per second rate. If the
delay is set to 0, the session will start immediately. If you have a delay and want to energize the tanning
bed, press the Start/Stop button again.
Timer-3
