A S S E M B L I N G - 3 × D O U B L E ( T W O E M I T T E R S ) H E AT E R S
J O I N E D
1.
Take the first heater and lie it face down on a flat surface.
2.
Take the second and third heaters and position them face down and parallel to the first.
3.
Push the bolts used to hold the wall brackets through the hole in the brackets on the
rear heaters and slide a shake-proof washer on all the threads from the protruding side.
4.
Slide the joining bars on each bolt and fit a washer and nut – do not fully tighten at this
point.
5.
Position the second heater so it’s parallel to the first and sitting flat.
6.
Take the third heater and a joining bar. Push a bolt and washer through the end hole
and place a serrated washer on the other side. Push the bolt through the bracket hole
on heater. Repeat on opposite side and secure with a washer and nut – do not fully
tighten at this point.
7.
Position the third heater so it’s parallel to the second.
8.
Line-up the bars of the first heater with the brackets of the second heater – they should
go on the inside faces like heater one.
9. Line-up the bars of the third heater with the brackets of the second heater – these
should go on the outside faces like heater three.
10. Push a bolt from the back of the joining bars through the holes putting a serrated
washer on each side of the heater bracket.
11. Fit a washer and nut to both sides and providing the assembly is sitting flat, fully tighten
both sides and also the nuts of the first and third heaters to the joining bars.
12. The heater is now ready for hanging.
9
2.
Fix the heater assembly to the chains via the hole in the centre of the joining bar as
shown in Fig. E and ensure the heaters face directly down when hanging.
3. Secure the supply cable so it is not resting on the body or obstructing the air-vents.
Always isolate the heater from the mains supply when adjusting the position.
