7. APPENDED SETTINGS FOR THE SERIES 230RM
30
When using the On-demand Remote Control System, the communications setup for the Series
230RM, wireless modem, and data collector should be set as follows.
G
• To change the baud rate settings to values other than those shown above, contact your Sokkia
agent.
$
• The baud rate of the RC controller can be switched using the dip switch.
C
"9.3 Communication Setup for the RC Controller"
When the search before distance measurement option is set to "RC", the Turning function (SET
ro Auto Point to detect prism) will be performed prior to distance measurement
"Search": Auto Pointing only
"RC":
Turning
"Off":
No search
G
• To perform measurement using the On-demand Remote Control System, the above setting must be
set to "RC".
• To perform measurement without using the RC controller, the above setting can be set to either
"Search" or "Off". If it is set to "RC" by mistake, an error will occur as the Series 230RM tries to find
the RC controller even though it is not in use.
7.3
Communication Setup
Baud rate
1200 bps or 9600 bps
Data bits
8
Stop bit
1
Parity
Non parity
7.4
Setup for Search Before Distance Measurement
[ OK ]
Search bef.DIST:
R C
PC
M o d e
R e f l e c t
E D M
F i n e " R "
: 3 0 m m
: P r i s m
Te m p .
Search area:HV Wide
E D M
:
Illum. hold:Laser
3 0 C
P r ess. : 1 0 3 4 h P a
p pm : - 3 0
0PPM
[ OK ]
