6. SETTINGS FOR THE SRX/NET
24
G
• Auto Pointing model does not support Auto Tracking.
X
PROCEDURE
1. Select "Motor" in <Configuration>.
Set Auto Pointing/Auto Tracking functions in
the Configuration tab.
For Auto Pointing only set "A.T. Setting" to
"Search". For Auto Tracking, set "A.T. Setting" to
"Track" and "Accu. search" to "Fine".
Set "Srch method" to "R.C.".
Settings and Options
(*: factory settings)
(1) Accu. search
&
Fine/Rapid*
(2) A.T. Setting
Auto Pointing model:
None/Search*
Auto Tracking model:
None/Search/Track*
(3) Srch method
&
G.S.*/R.C.
&
Accu. search
Set to "Fine" for greater accuracy during Auto Pointing. Make sure that the prism is securely
mounted on a tripod etc.
Set to "Rapid" when supporting the pole by hand.
When "Fine" is set the SRX/NET checks that the prism position is stable, then searches for the
prism direction. Once the SRX/NET confirms that the prism is sighted at the approximate center
of the field-of-view, Auto Pointing is complete. Although this setting provides greater accuracy,
when supporting the pole by hand, hand movements will result in Auto Pointing taking too long
to complete and a "Time out" error will occur.
When "Rapid" is set however, Auto Pointing can be performed even with slight instability of
prism position or minor shifts of target position in the field-of-view. The SRX/NET will use the
data obtained to determine the direction of the target.
Auto Pointing performed using the "Rapid" setting can be completed in a much quicker time than
the "Fine" setting.
"Fine" is recommended when a high level of measurement accuracy is needed. Sighting
accuracy for Auto Pointing will be the "Fine" setting. The range for the offset between the target
and reticle after Auto Pointing completed changes as shown below depending on the Accu.
search. setting.
6.2
Settings for Auto Pointing and Auto Tracking
