P a g e
|
16
Figure 20: Ring installation holes on bottom of Versa-Plate.
Figure 21: Versa-Plate with first two ring segments installed.
Place the scope inside the mounted rings (see Figure 22) and assemble the rest of the three ring
segments around the telescope using eight ¼-20 x ½-inch SHCS (Figure 23) without tightening them
down all the way. This allows for ring adjustment so the telescope is the in the desired orientation, as
well as the long flats being parallel. The rings may not fit snug against the telescope body yet, once
you’re satisfied with where the rings are install, move on to “
” section.
Be careful, the telescope is not all the way secured! Do not let go of the telescope until
the “Set Screw Adjustment” has been made.
