Softube AAX DSP, User Manual, Page: 38 / 182

38 | BASS AMP ROOM
Clicking on the background while holding the Shift- key
toggles through the cabs without any sliding animations.
Mix Panel (Bottom Area)
In the mix panel, you can change the balance be-
tween the amplifier signal and the D.I. signal. The
tonality of the D.I. signal can be changed with the
three EQ knobs and the compressor/limiter. You
can also change the phase of the amplifier signal
and adjust the output volume.
User Interface
Apart from a good sound, work flow is a crucial
element of our design – the amps and mics should
work just as they do in a real studio. We have tried
to imi tate this as much as it is possible in a compu-
ter environment, and if you have experience working
in real studios, you will notice that Bass Amp Room
handles and sounds just the way you expect it to.
Amp Panel (Top Area)
In the Amp Panel, you can alter the settings of the
amp by clicking the knob and dragging the mouse
up and down, or left to right. Switches can be
switched either by clicking on them, or by click and
dragging the mouse. In some hosts you can change
the behavior of the mouse, but the default behavior
of Bass Amp Room is the one described above.
Room View (Middle Area)
In the Room View you can do two things: select the
other cabinet or change the mic’s position.
Mic Position
When the mouse is located over a mic stand, the
mouse pointer changes to an “up down” arrow and
the mic gets a copper/goldish glow. Click -and- drag
the mouse up or down to change the position of the
mic stand. The microphone moves along a predeter-
mined path, so you only need to move the mouse up
or down, not to the left or right.
Cabinet Selection
You can change the cabinet by clicking on the
background and dragging the mouse to the left or
right. The mouse pointer becomes a “left -right”-
arrow when you are pointing at the background to
indicate that it is possible to change cabinet.
Amp Panel
Room View
DI and Mix Panel