SoftBank P00000401A01, Quick Manual

Page: 13 / 24

12
■ HEPA Filter
(Inside the cover)
■ Battery
(Inside the Battery
Compartment)
■ Cliff Sensor
■ Brush
■ 2D/3D Camera
(Sensor)
■ LIDAR Sensor
Front / Side Back
Top
Bottom
■ Touch Display
■ Vacuum Power Button
■ Autonomous Clean
Start / Stop Button
■ Max Power Mode Button
■ Emergency Stop Button
■ Hopper Tray
■ Dustbin
■ Secondary Battery
Power Button
■ Steering Handle
■ Main Power Switch
■ Pager holder
3 Names of Parts
4 Check before using
1
Charge the Battery
Insert the fully charged
Battery into the Battery
Compartment
Lock the Battery, and
close the Battery door
2 3
Charge the Battery and insert it to the Machine
Battery charging
status light
* Once the battery is recharged,
it flashes in green
Hold the handles with both
hands and be careful not to
drop it on the floor.
Check
Charging
Status
Hopper Tray
From the back of the machine,
check if the Hopper Tray is installed
correctly.
Dustbag
Check that the Dustbag is
installed and the Dustbin pin
is afloat
Open the Dustbin Cover
1 2
HEPA Filter
Check the other HEPA filter with the same procedure.
1
To remove the filter
cover, turn it to the left
2
Turn the filter to
the right until it
clicks to close
If the filter is not installed, install it into the Machine.
Check that the HEPA Filter, Dustbag and the Hopper Tray are Installed Correctly
Turn the Emergency Stop Button
to the right to release.
Release the Emergency
Stop Button