SoftBank 931sc, User Manual

Page: 81 / 330

Calling
3-8
3
Emergency Numbers
Call 110 (Police), 119 (Fire & Ambulance) or 118
(Maritime Safety Agency). These numbers can be
dialed even when certain Call Barring settings
are active. See details below.
931SC Status
Emergency
Numbers
Offline mode activated ( f P.1-16) None
Call Cost limit exceeded ( f P.14-8) 110, 119, 118
Phone lock activated ( f P.11-3) None
Password lock activated ( f P.11-4) 110, 119, 118
Required PIN not entered ( f P.11-4) None
USIM Card not be authenticated
(
f P.11-5)
None
Outgoing Call Barring activated
(
f P.3-20)
110, 119, 118
Emergency Location Report
When calls are placed to Police or other
emergency agencies from handset, handset
location information is automatically sent to
the corresponding agency.
Handset transmits location based on base
station positioning information.
・
Location accuracy may vary by geography or
signal conditions. Always verify your location with
address or nearby landmark.
・
Base station positioning accuracy ranges from
several hundred meters to 10 kilometers. This
information may differ from actual location due to
distance of the closest base station location.
・
This function is only available if the agency
receiving an emergency call has implemented
infrastructure for receiving location information.
・
If you hide Caller ID by dialing 184 before calling
an emergency number, your location information
is not sent. However, authorities may access this
information when necessary.
・
No subscription/communication fee required.
Note
・
Emergency calls may not be possible
outside Japan depending on available
network, signal conditions or handset
settings .
Hold, Answering Machine &
Black List
Hold Incoming Call
Place call on hold and reconnect.
a Hold
during call
・
When a call is put on hold, the party on hold
hears a hold tone and neither party can hear the
other's voice. A subscription to Call Waiting or
Group Call is required to use this function. If you
do not subscribe to either service, this function is
disabled.
・
To reconnect call Tap
Hold
.