8
5. Clip the other cable clip on the upper handle frame, and
secure the cable inside the cable clips (Fig. 4).
m
WARNING!
Make sure all handle knobs are properly
tightened before using the electric cultivator.
Operation
Intended Use
The TJ605E-ELT electric cultivator is designated with a
rated input power consumption of 1440 Watts.
Designed for small gardens and flower beds, this electric
cultivator effectively loosens and turns over new soil. It
may also be used to mix coarse soil with fertilizer, peat, and
compost. This product may not be used to till extremely dry or
wet soil.
The use of this product in rain or wet conditions is prohibited.
For safety reasons, it is essential to read the entire instruction
manual before first use and to observe all the instructions
contained within this manual.
This product is intended for private domestic use only. It is not
intended for any commercial trade use. It must not be used for
any purposes other than those described.
Connecting to Power Supply
NOTE: For safety reasons, this product is equipped with a short
power cord. Do not connect the electric cultivator directly
to the power supply using this power cord. A proper extension
cord is required for operation. Observe the technical requirements
for this product when purchasing an extension cord.
m
WARNING!
For your safety, it is required that the plug
attached to this electric cultivator be connected to an
approved extension cord. The extension cord must be suitable
for outdoor use, with all sockets protected against water
splashing. Ensure the extension cord is of the proper size
and type for your product (≥ 1.5 mm²). Always use a residual-
current device (RCD), or residual-current circuit breaker (RCCB)
protected power supply.
1. Connect the electric cultivator to a working 120 V
outlet using a heavy-duty outdoor extension power cord,
such as the Snow Joe
®
+ Sun Joe
®
SJTW-A 14-gauge
50-foot extension cord with lighted end (Model
PJEXT50-B). Visit sunjoe.com to order online or call
1-866-SNOWJOE (1-866-766-9563) to order by phone.
2.
Make a loop in the extension cord and push it up through
the hole in the handle and around the cord restraint hook
(Fig. 5), then connect the extension cord to the appliance
cord.
Fig. 3
Middle
handle
frame
Upper
handle
frame
Fig. 4
Cable
Cable clips
Fig. 5
Extension cord
Appliance cord
Restraint hook
