20
Replacing Impeller
1.
To uninstall the impeller, repeat steps 1 to 7 (Figs. 30 – 36).
2.
Disassemble the worn impeller from the impeller shaft by
removing the 2 spring pins (Fig. 39).
3.
Install the replacement impeller by following the above
steps in reverse order.
Replacing Auger Belt
1.
Open the battery compartment cover and remove the 2
screws inside the compartment (Fig. 40).
2.
Disassemble the motor cover by removing the 4 screws
and washers (2 on each side) and open the motor cover
(Figs. 40 & 41).
3.
Remove the M6 bolt and sprocket cover from sprocket 1
then remove the auger belt from pulley 1 (Fig. 42).
4.
Roll the new auger belt onto the bottom of pulley 1. Then
roll it to the sprocket 1 (Fig. 42).
5.
Reinstall the sprocket cover and M6 bolt to sprocket 1
(Fig. 42).
Replacing Drive Belt
1.
Carefully turn the snow blower over, as shown (Fig. 43).
Fig. 39
Spring pin
Impeller
shaft
Impeller
Fig. 40
Screw
Battery
compartment
cover
Screw +
washer
Fig. 41
Open motor cover
Fig. 42
Auger belt
Sprocket cover
M6 bolt
Sprocket
1
Pulley
1
Fig. 43
Summary of Contents for iON24SB-XRP-RM
Page 26: ...25 NOTES...
Page 28: ...snowjoe com...
