116
Model: Snorkel SR9244 SR1054
Part Number: 159-0037-000
Snorkel International, LLC
2009 Roseport Road
Elwood, KS 66024
GENERAL INFORMATION
5.1
•
Park the machine on level ground.
•
The work area must be clean and dry.
•
Maintenance, repair and adjustment operations must be carried out by qualified and skilled
personnel with the machine switched off.
•
It is forbidden to carry out maintenance when the machine is moving.
•
The frequency indicated in this manual must be complied with. Damaged or worn parts must be
immediately repaired or replaced.
•
Always keep the machine clean from debris and eliminate any grease or oil deposits.
•
Isolate the battery if arc welding is to be carried out on the machine or work is to be performed on
the wiring system.
•
If electric arc welding must be performed, disconnect the transmission control units inside the
general electrical box.
•
If electric arc welding must be performed, disconnect the diesel engine control units.
•
When arc welding, connect the welder mass to a point in direct contact with the area to be
welded avoiding intervention on sliding parts such as joints, bearings, hydraulic cylinders.
•
Wear protective glasses and mask when using compressed air for cleaning. Do not direct the jet
towards the skin or the eyes.
•
Use gloves and glasses when handling detergent liquids and/or lubricants.
•
After maintenance and before enabling the machine, make sure that any safety devices removed
previously have been restored.
•
If the machine must be lifted, make sure it is supported on a solid and safe base.
•
When operating under mobile lifted parts (e.g. telescopic boom), block the hydraulic cylinder
movements with the spacers and rest them on top of safe and strong supports.
