Snorkel EPV Series, Operator'S Manual

Page: 33 / 57

8. Daily Inspection and Maintenance
At the start of each work day (or 8 hour shift), an
EPV qual i fied op er a tor must per form the Daily In -
spec tion and main te nance (or Pre-Op er a tion In -
spec tion as it is some times re ferred to), as listed in
the ta ble be low.
The pur pose of the Daily In spec tion and Main te -
nance is to keep the EPV in proper work ing con di -
tion and to de
tect signs of mal func tion at the
ear li est pos si ble time.
Set the Key Switch to OFF be fore you be gin this in -
spec tion.
De fec tive parts and/or equip ment mal func tions
jeop ar dize the safety of the op er a tor and other per -
son nel, and can cause dam age to the ma chine.
DO NOT operate an EPV that is known to be
damaged or malfunctioning.
R e p a i r a l l e q u i p m e n t d a m a g e o r
malfunctions, before placing the EPV into
service
EPV Series – 1596(A) Rev A page 8 - 1
DANGER
Item Service Required
Fuel level * Visually inspect
Fuel tank cap * Check to see that cap is tight
Fuel leaks * Visually inspect (hoses and connections etc)
Engine oil * Check oil level (between dipstick lines)
Engine cover * Check that latches are secure
Wiring harnesses and connectors Visually inspect (installation, operation)
Battery terminals *
Visually inspect (no corrosion)
Battery fluid level *
Visually inspect (covers plates)
Hydraulic tank cap Visually inspect installation)
Hydraulic oil level Check fluid level (at line on side of tank)
Hydraulic oil leaks Visually inspect (hoses,tubes)
Bolts and fasteners Visually inspect (looseness)
Structural damage and welds Visually inspect (welds, cracks, dents)
Lanyard anchorages Visually inspect (condition)
Bubble level Visually inspect (condition)
Placards, decals, and Operators Manual Visually inspect (installation and condition)
Ground controls Actuate and visually inspect for operation
Emergency lowering Check operation (causes correct motion)
Platform controls Actuate and visually inspect for operation
Flashing light Visually check (operation)
RCD / ELCB (option) Check operation
Low Voltage Insulated EPV Only
Insulation covers Visually inspect (for cracks or damage)
Fibreglass basket Visually inspect (for cracks or damage)
Fibreglass basket emergency exit hatch Check operation
Boom insulation covering Visually inspect (for signs of cracking or corrosion)
Cleanliness Check all insulated surfaces (including basket) for road grime,
dirt, and other contaminants
Note:
If your EPV is driven by a PTO from the truck the in spec tion items marked with (
* ) can be by passed.
■
Daily Inspection and Maintenance Table