7
Install the base station
1�
Plug one end of the Ethernet cable into the Ethernet port on the rear of the base
station, and plug the other end of the cable into your network router or switch�
2� If the base station is not using power from a PoE-capable network router or
switch:
•
Connect the provided DC 5V 800mA power adapter to the base station power
jack�
•
Plug the power adapter into an electrical outlet that is not controlled by a wall
switch�
IMPORTANT INFORMATION
•
Use only the DC 5V 800mA power adapter provided with the product�
To order a replacement power adapter, visit our website at
www.snomamericas.com
�
•
The power adapter is intended to be correctly oriented in a vertical or floor mount
position� The prongs are not designed to hold the plug in place if it is plugged into a
ceiling, under-the-table, or cabinet outlet�
Install the conference phone battery
•
Risk of explosion! Batteries should not be exposed to excessive heat
such as bright sunlight or fire�
•
Use only the supplied battery
1�
After removing the battery door, plug the battery connector securely into the
socket inside the battery compartment�
2� Place the battery into the battery compartment with the label
THIS SIDE UP
facing
up�
3� Attach the battery door, and secure it in place with the provided screws�
