![background image](http://html.mh-extra.com/html/snell-and-wilcox/shdftrx/shdftrx_operation-manual_1309068013.webp)
SHDFTRX
OPERATION
SHDFTRX
Version 1 Issue 5
180203
13
WDM Transmitter Interfaces
Electrical HD-SDI - Only
Used On :
SHDFTRX0WQC
SHDFTRX6WQD
The high definition serial digital electrical input for
the WDM laser transmitter is the same as for the
standard transceiver options. It is shown opposite
labelled as
H2
on the rear panel. In the same
manner the electrical loop through of the
transmitter input is also the same as for the non-
WDM options and is shown in the diagram opposite
labelled as
H3
. However there is no independent
access to the optical output from the transmitter
from the rear panel in the WDM case. The area
used for the optical transmitter interfaces are
shown in the diagram opposite as blanked off.
Standard Receiver Input
Optical HD-SDI Input
Used On :
SHDFTRX0WQ4
SHDFTRX0WQ2
SHDFTRX0WQ0
The high definition serial digital optical input is
connected to an SC/PC single mode panel uniter.
This connector is shown opposite and is labelled
H8
on the rear panel. This is a single optical
wavelength interface in these cases.
Standard and WDM
Receiver Outputs
Electrical HD-SDI : Quad Outputs
Used On :
SHDFTRX0WQ4
SHDFTRX0WQ2
SHDFTRX0WQ0
SHDFTRX0WQC
SHDFTRX6WQD
The four high definition serial digital electrical
outputs are available from four 75
Ω
BNC
connectors. The same digital bitstream is provided
by all four connectors. This bitstream is a reclocked
version of the optical signal provided to the optical
receiver. These electrical outputs are labelled as
H4
,
H5
,
H6
, and
H7
on the rear panel as illustrated
in the diagram opposite.