![background image](http://html1.mh-extra.com/html/snell-and-wilcox/iqotr30/iqotr30_operators-manual_1309066019.webp)
Version 1 Issue 1
www.snellgroup.com
IQOTR30
Page 17
RollTrack
The RollTrack settings allow information to be sent, by means of the RollCall
network, to other compatible units on the same network.
Use the settings on the
RollTrack
screen to:
•
Enable or disable the RollTrack functions.
•
Configure up to 16 RollTrack outputs.
•
Specify the conditions that trigger RollTrack data transmission.
•
Set RollTrack destinations.
•
Specify the RollTrack commands to be sent.
RollTrack Sources
The RollTrack Source specifies the source of the information that triggers the
transmission of data.
RollTrack Addresses
The full RollTrack Address comprises four sets of numbers. For example,
0000:10:01*99.
The first set, 0000 in the example, is the network segment code number.
The second set, 10 in the example, identifies the (enclosure/mainframe) unit.
The third set, 01 in the example, identifies the slot number in the unit.
The fourth set, 99 in the example, is the RollCall ID of the destination unit - a user-
configured number that uniquely identifies the destination unit in a multi-unit
system. If it is set to anything other than 00 the unit will respond to RollTrack
commands. If left at 00, an incorrectly fitted unit may respond inappropriately.
RollTrack Commands
Each RollTrack command comprises two sets of numbers, for example, 33039:3.
The first set, 33039 in the example, is the RollTrack command number, which
identifies the command.
The second set, 3 in the example, is the value that is sent with the command.
Using RollTracks
To enable or disable RollTrack functions:
•
To enable the RollTrack functions, clear the
Disable All
check box.