IQEDGE
RollCall Control Panel
Issue 1 Rev 1
Page 47
© 2017 SAM
5.22 Logging - Spigot n
The
Logging Spigot
pages are used to select the fields to be logged for each available
spigot. Depending on whether the spigot is an input or an output, the appropriate log fields
are shown. Enable fields to be logged as required.
An additional field is provided for the user to optionally specify a name for the input.
Where N is the input number
Figure 27 Logging Spigot n Page
Log Field
Description
INPUT_N_IDENT=
Displays a system-defined identifier for the input, based
on the rear ID.
INPUT_N_NAME=
Displays name of the input, as defined by the user on the
Setup
page. See section 5.25.
INPUT_N_STATE=
Displays input state. Valid values are:
•
OK
- Input signal good.
•
WARN:Error
- Input signal present but does not
match reference standard or selected standard.
•
FAIL:Lost
- Input signal not detected.
INPUT_N_TYPE=
Displays the input type, HD/SD/3G SDI.
INPUT_N_STANDARD=
Displays the input standard, PAL/NTSC/625 Mono/525
Mono.
