Snapper YARD CRUISER YZ13331BE, Safety Instructions And Operator'S Manual

Page: 17 / 32

17
Section 4 - ADJUSTMENTS & REPAIR
WARNING
Before attempting any adjustments or repairs, STOP
the engine, remove the key, remove the spark plug
wire(s) from the spark plug(s) and secure wire(s)
away from plug(s).
4.3.7. MOWER DECK ADJUSTMENT (LEVELNESS)
Side-To-Side (33” & 38” Decks)
Before making deck leveling adjustments, check
the tire pressure. Check tires and add or release air
as needed to bring pressure to 12 psi in front and 12
psi in rear tires. If tires are properly inflated and
mowing is still uneven, adjust side-to-side deck
levelness as follows:
1. Place YARD CRUISER on a smooth level
surface.
2. Turn engine off and remove key, remove
spark plug wire(s) from spark plug(s) and secure
wire(s) away from plug(s).
3. Place a piece of angle iron, pipe, or similar
object under center of deck at the rear.
4. Remove rear hanger chains and allow center,
rear of deck to rest on angle iron.
5. Measure the distance from blade tips to floor. If
the measurement is within 1/8” from side-to-side,
the deck levelness is satisfactory. If the difference
from side-to-side is greater than 1/8”, continue to
the next page for adjustment. See Figure 4.9.
FIGURE 4.9
6. Loosen the shoulder bolt that retains the
eccentric.
7. Turn eccentric “UP” or “DOWN” as required
until blade tips are within 1/8” of the same
distance from the floor. See Figure 4.10.
8. Tighten shoulder bolt loosened in Step “f”.
9. Readjust rear hanger chain pivots to align
with holes in support brackets.
10. Reconnect hanger chains, remove angle
iron, pipe, etc. and recheck side to side level.
Adjust either chain as needed to result in blade
tips being within 1/8” of the same distance from
the floor.
11. Proceed to check front to rear deck pitch.
FIGURE 4.10
FRONT OR REAR VIEW OF DECK
TWIN BLADE DECK
X
X-1/8”
SIDE SIDE
ANGLE
IRON
SINGLE BLADE DECK
SIDE
SIDE
X-1/8”
X
ANGLE IRON
38” DECK SHOWN
LOOSEN
SHOULDER
BOLT
UP
DOWN
ECCENTRIC