30
Headlight Replacement
1. Open the hood (Figure 22).
2. Remove the forward heat shield.
3. Remove the light bulb socket from the bezel by twist-
ing it counterclockwise and pulling it out.
4. Use a rag or gloves to remove and replace the light
bulb with an identical halogen bulb.
DO NOT TOUCH
THE BUlB WITH YOUR BaRE HaNDS.
5. Reinstall the socket into the bezel.
Taillight & Dash light Replacement
1. Twist the socket counterclockwise and pull out to
remove it from the taillight or dashboard display
(Figure 23).
2. Remove and replace the old bulb with a new identical
bulb.
3. Reinstall the socket into the taillight bezel or dash-
board display.
Figure 22. Headlight Replacement
Figure 23. Taillight Replacement
Gauge Wheel adjustment
The mower gauge wheels can be placed in two positions
depending on the height of cut. When using higher cut-
ting heights, set the wheels in the lower position. When
using lower cutting heights, set the wheels in the upper
position. To adjust:
1. Remove the hair pin clip (A, B, Figure 24).
2. For upper position, install the pin (A) through the
spindle above the bracket (C). For the lower position,
push down on the top of the spindle, and install the
hair pin clip (B) below the top of the bracket (C).
Figure 24. Gauge Wheel adjustment
a
B
C
Not
for
Reproduction
