19
SECTION 3 – MAINTENANCE
WARNING
DO NOT attempt any adjustments, maintenance,
service or repairs with the engine running. STOP
engine. Set park brake. Shift transmission to
neutral. Remove key. Remove spark plug wire from
spark plug and secure away from plug. Engine and
components are HOT. Avoid serious burns, allow
ALL parts to cool before working on machine.
3.1 INTRODUCTION
To retain the quality of the Snapper Grounds Cruiser utility
vehicle, use genuine SNAPPER replacement parts only.
Contact a local SNAPPER dealer for parts and service
assistance. For the correct part or information, always
mention the model and serial number. SNAPPER
recommends returning the Grounds Cruiser to an
authorized SNAPPER dealer annually for inspection and
addition of any new devices, which might upgrade the
safety of the machine. For the nearest SNAPPER dealer in
your area, check the Yellow Pages under the heading
“LAWN MOWERS”. For engine parts and service, look for
the engine manufacturer’s dealers under the heading,
“ENGINES – Gasoline”.
3.2 SERVICE - AFTER FIRST 5 HOURS
Routine maintenance is important to the performance
and life of your Snapper Grounds Cruiser. Service
performed properly and at the recommended interval is
essential. Refer to Section “MAINTENANCE
SCHEDULE” in this manual and in the Engine Owner’s
Manual. Carefully complete all of the recommended
service procedures.
IMPORTANT: Before working under a raised cargo
bed, the bed must be empty and the prop rod securely
latched.
3.2.1. Change Engine Oil
1. Raise empty cargo bed and secure with prop rod.
2. Locate oil drain plug on engine at bottom front
center of crankcase. See Figure 3.1.
FIGURE 3.1
3. Place a 2 quart minimum capacity container
under the drain plug.
4. Loosen or remove oil fill cap on engine.
5. Turn drain plug counter-clockwise and remove.
Allow sufficient time for oil to drain completely.
6. Reinstall the oil drain plug. Torque plug to 12
ft-lb.
7. Fill engine crankcase to proper level with new oil.
Refer to the Engine Owner’s Manual for
crankcase capacity and oil specifications. Do not
overfill. The machine must be on a level surface
and the dipstick unthreaded when checking
engine oil level.
8. Lower cargo bed and latch securely.
IMPORTANT: Any oil spilled during draining or filling
must be cleaned off of the machine before operating.
Dispose of drain oil properly.
3.2.2. Service Engine Air Cleaner
The engine is equipped with a large capacity air
cleaner. Service and replacement intervals will vary
depending on operating conditions.
1. Locate engine air cleaner. Cover is retained with
two latches. Unsnap both latches and remove
cover. See Figure 3.2.
NOTE: Viewed from top, cargo bed removed.
FIGURE 3.2
2. Remove air filter element.
3. Clean inside of filter canister carefully - DO NOT
allow debris to enter intake tube.
LATCHES
CANNISTER
COVER
OIL DRAIN PLUG
NOTE: HEAT SHIELD REMOVED FOR CLARITY.