19
2.
Remove the cover (B, Figure 19).
3.
To prevent debris from falling into the carburetor, carefully
remove the pre-cleaner (D, Figure 19) and the filter (C) from
the air filter base.
4.
Remove the pre-cleaner (D, Figure 19), if equipped, from
the filter (C).
5.
To loosen debris, gently tap the filter (C, Figure 19) on a
hard surface. If the filter is excessively dirty, replace with a
new filter.
6.
Wash the pre-cleaner (D, Figure 19), if equipped, in liquid
detergent and water. Allow the pre-cleaner to throughly air
dry. Do not oil the pre-cleaner.
7.
Assemble the dry pre-cleaner (D, Figure 19), if equipped,
to the filter (C).
8.
Install the filter (C, Figure 19) and the pre-cleaner (D), if
equipped, onto the air filter base. Make sure the filter fits
securely on the air filter base.
9.
Install the cover (B, Figure 19) and secure with the
fastener(s) (A). Make sure the fastener(s) is tight.
Check Safety Interlock System
1.
Start the mower.
2.
Release the blade control. The engine must stop within 3
seconds.
WARNING
Unsafe Operation Hazard
If the engine does not stop within 3 seconds, do not use the
mower. Bring the mower to an authorized dealer for service.
Clean Debris Off Mower
WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
Laceration Hazard
• Wear heavy leather gloves when handling or working
around cutting blades.
• Blades are extremely sharp and can cause severe injury.
1.
Clean dirt and debris from the top of the mower deck.
2.
Clean any debris buildup on or around the engine, etc.
While cleaning, check components for wear or damage. Replace
worn or damaged components immediately.
Storage Procedure
WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or service
with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
Laceration Hazard
• Wear heavy leather gloves when handling or working
around cutting blades.
• Blades are extremely sharp and can cause severe injury.
Prepare the mower for end-of-season storage as follows:
1.
Disconnect the spark plug wire and secure away from the
spark plug.
2.
Drain the fuel tank and let the engine run until all fuel is out
of the carburetor.
18
Not for
Reproduction
