Not for
Reproduction
30
All Other Models:
31
2.
Check the oil level when the unit is cold. The oil should be
up to the "FULL COLD" mark (B) on the transmission oil
tanks. If the oil is below this level, proceed to step 3.
3.
Before removing the tank cap (C), make sure that the area
around the tank cap and fill neck of the tank is free of dust,
dirt, and other debris. Remove the tank caps.
4.
Add oil up to the "FULL COLD" mark.
5.
Re-install the tank cap.
6.
After adding oil to the tanks, it may be necessary to purge
air from the hydraulic system. If the unit is not driving
properly perform the
Purging the Air from the Hydraulic
System procedure.
Transmission Oil Filter Change
Change Interval: Every 400 Hours or yearly (Initial hydraulic
oil and filter change after first 100 hours of operation).
Filter Part Number: 5101987X2
Note: Removing the oil filter from the transaxle will drain the oil
tank. Have a suitable container ready to catch any spilled oil.
The manufacturer recommends that this be a dealer-only service
item.
1.
Locate the hydraulic oil filter on the side of the transaxle.
2.
Remove the oil filter cover (A, Figure 32) from the transaxle
to drain the oil. Remove the O-ring (B) from the cover and
discard the O-ring.
32
3.
After the oil has drained from the transaxle, remove the oil
filter (C) from the transaxle housing.
4.
Install a new filter and a new O-ring onto the filter cover and
install the filter cover. Torque the filter cover to 480-580
in-lbs (54.2 - 65.5 Nm).
5.
Remove the top oil fill vent port (D) and fill the transaxle
with new 20W50 motor oil through the expansion tank until
the oil reaches the oil fill vent port.
29
