9
Luma 500/700 Series Dome IP Camera
Install and Run the Luma Utility
Use the Luma Utility to locate your camera and set it up.
Visit your product page at SnapAV.com and download the
Luma Utility installer from the Support tab.
You must use
v3.0.0.53 build 20170426 or later! Earlier versions of the
utility will not work!
Run the installer. You can click through and accept the defaults.
Pre-Installation Camera Configuration
You’ll find it easiest to connect the camera directly to your PC, making
most adjustments to the camera from the convenience of your table
(prior to physical installation), rather than from atop a ladder.
Connect the camera to your PC and run the Luma Utility.
It searches for attached Luma Surveillance devices. If your
camera does not appear, check the connection, ensure the
camera is powered up, then click the
Refresh
button.
