7
AC/DC POWER DISTRIBUTION
The DC output of the Camera Power supply feeds through a harness on the back of the cabinet. Both the 5V
and 12V power is fused at this location. Should a camera stop working checks should be made to both fuses
for proper continuity and both the 5V and 12V be checked for proper power using a VOM.
From Power
Supply
HUB BOARD
The HUB board is housed inside an aluminum extrusion behind the camera beam. The HUB board’s purpose
is to pass information to and from each of the camera’s directly to one of the USB Ports on the back of the
PC. The HUB board has 4 USB connectors for either a two camera system or a three camera system. The
Db9 connector at the bottom of the HUB Board is a direct link to the PC, the other 3 connections are equiva-
lent for the camera’s, any camera will plug into any of the three camera connections. There is also a Db15
connector on the HUB Board for future motor control.
Camera Pwr.
Motor Control
To PC USB
Camera Pwr.
Camera Pwr.
Camera USB
Camera USB
Camera USB
Incoming
Camera Pwr.
From PC USB
inside cabinet
view
Summary of Contents for UHR Ultra
