Scanner - Automotive
Features and Icons
23
Figure 6-4
Typical systems menu
If a system (e.g. Engine, Transmission, Antilock Brakes, etc) is selected, the
diagnostic tool may establish communication with the vehicle, then display the
system main menu (available tests) (
). For sub-menu option
information, see
.
Figure 6-5
System main menu
Instant ID
The Instant ID function, can save time when initially identifying a vehicle, by
automatically communicating with the vehicle to complete the vehicle identification
process.
This function requires specific vehicle support requirements, and connection
procedures to operate.
•
Vehicle requirements
:
–
Vehicle must support Mode $09 VIN.
-
Note:
Mode $09 VIN is mandated on 2008 and newer vehicles.
–
Vehicle must be equipped with Hi Speed CAN or J1850 communication
protocol.
•
Connection procedure requirements:
1.) Turn the vehicle ignition on.
2.) Connect the data cable to the diagnostic tool.
3.) Connect the data cable to the vehicle data link connector (DLC).
4.) The diagnostic tool should turn on automatically. If required, turn the
diagnostic tool on.
An audible "beep" will sound approximately 6 seconds after boot-up, if the VIN
is read.
Note:
No visual confirmation is displayed.
5.) Select
Scanner
.
When Scanner is selected, a screen may briefly appear informing you the
diagnostic tool is attempting to automatically complete the vehicle
identification process.
6.) After the vehicle has been identified, the vehicle confirmation screen
displays. If the vehicle information is correct, select
OK
to continue.
NOTE
Depending on the vehicle, Instant ID may occur automatically and only ask
you to confirm the vehicle, or additional screen prompts may be displayed to
enter vehicle information.
