Snap-On POLARTEK EEAC330, Manual

Page: 21 / 46

• 21 •
MANUAL PROCEDURE
In the MANUAL PROCEDURE, all the operations can be
performed individually with the exception of the
recovery/recycling phase, which is automatically followed by
used oil discharge.
From the MAIN MENU:
Select the MANUAL PROCEDURE, the following screen will be
displayed:
RECOVERY/RECYCLING
Before the recovery, start the vehicle engine with the hood
closed (the air conditioner must switch OFF) for 10 minutes to
warm the engine. Switch off the vehicle engine.
Connect the hoses to the A/C system with the quick-connect
couplings, bearing in mind that BLUE must be connected to the
low-pressure side and RED to high pressure.
If the A/C system is equipped with a single quick-connect
coupling for high or low pressure, connect only the relative hose.
From MANUAL PROCEDURE, select RECOVERY/ RECYCLING, the
following screen will be displayed:
Type the plate of the car, press ENTER to confirm. ESC to return
back.
NOTE : the numerical keys include an alphabet that is used
similar to text messaging; for example: press “2” once to display
“2”, twice to display “A”, three times for “B”, four times for “C”, five
times for “a”, six times for “b”, seven times for “c”, eight times for
“2” again.
The following screen will be displayed:
Connect and open the coupling to the A/C system, open HP and
LP side valves and then press ENTER. Press ESC to return back.
The following screen will be displayed:
GAS EXTRACTION FROM A/C SYSTEM 1
st
PHASE
Recovered gas
Tank Pressure
A/C pressure
Tank temperature
R134a MANUAL PROCEDURE
RECOVERY / RECYCLE
lb
psi
psi
°F
Connect and open HP and LP coupling to A/C system
Open HP and LP side valves and press ENTER
R134a MANUAL PROCEDURE
RECOVERY / RECYCLING
Inset vehicle
Plate number:
___________________
R134a MANUAL PROCEDURE
RECOVERY / RECYCLE
R134a MANUAL PROCEDURE
RECOVERY & REC. VACUMM
OIL INJECTION CHARGE
R134a
mm/dd/yyyy
hh:mm
xxxxxxx
AUTOMATIC MANUAL
SETUP MAINTENANCE