9
EEWB331B
2.1 HOOD GUARD INSTALLATION
The safety hood guard is standard equipment and
must be installed prior to use.
Refer to Figure 8 for hood guard installation.
Parts Required:
(1) Hood Guard Assembly
(2) 3/8” - 16 x 2” HHCS
(2) 3/8” x 16 Keps
Position the hood guard in the raised (up) position.
Slide the hood guard support tube over the frame pivot
shaft protruding from the right side of the balancer
cabinet.
Line up the mounting holes in both the pivot shaft
and the guard support tube. Secure the guard with
3/8” hardware (Figure 8).
Figure 6
2.0 BALANCER INSTALLATION
Mounting the Shaft Adapter
IMPORTANT!
CHECK THAT THE SURFACES ARE PERFECTLY
CLEAN AND NOT DAMAGED. AN INCORRECT
MOUNTING MAY RESULT IN SIGNIFICANT
IMBALANCE.
A.
Mount the threaded shaft onto the arbor of the
balancer
. Tighten fi rmly using supplied rod. (Figure 6).
C.
Place cones and other accessories onto the
accessory pins.
B.
Install the accessory pins (Figure 7). Tighten fi rmly.
2.2 ELECTRIC INSTALLATION
A N Y E L E C T R I C A L W I R I N G M U S T B E
PERFORMED BY LICENSED PERSONNEL.
ALL SERVICE MUST BE PERFORMED BY AN
AUTHORIZED SERVICE TECHNICIAN.
Check on the plate of the machine that the electrical
specifi ca tions of the power source are the same as
the machine. The machine uses 115VAC, 60Hz, 1Ph.
A 10 amperes power line capacity is recommended.
NOTE: Any electrical outlet installation must be
verifi ed by a licensed electrician before connecting
the balancer.
NOTE: This machine performs a self-test routine on
start-up. There will be a delay of several seconds
before the display is activated.
Figure 7
Figure 8
