1. To attach, insert nozzle into female quick-disconnect spray wand and
press to snap in the nozzle.
2. To detach, slide down slip ring on female quick-disconnect to eject
the nozzle.
PRESSURE PUMP TO WATER SUPPLY
1. Connect the garden hose to the water supply and turn
water supply on to fill the hose with water and also remove
any debris in the hose. Turn OFF water supply.
2. Make sure that the filter inside Pressure Washer water inlet
is clean and undamaged. Thread the garden hose fitting
into water hose inlet. FIRMLY hand tighten the inlet nut.
3. Turn on water supply.
The Pressure Washer requires a minimum of 20 PSI and a
flow rate of 5 GPM.
PREPARING THE PRESSURE WASHER
Improper treatment of Pressure Washer can damage internal components
and shorten the life of unit.
Failure to follow this warning will void warranty.
PRESSURE PUMP
The pressure pump requires no preparation. If you notice any sign of oil leakage in
and around the pump, DO NOT operate the pressure washer. Please call the pres-
sure washer helpline at 1-888-278-8092.
ADDING ENGINE OIL
1. Move the Pressure Washer
OUTSIDE
and place on a flat and level
surface.
2. Remove the engine oil dip stick and place funnel in the oil reservoir.
3. Pour the supplied engine oil (30 weight)) until oil level reaches
the threads inside the oil reservoir.
4. Hand tighten oil dip stick and wipe off any spilled oil.
18
SLIP RING
DIP STICK
Summary of Contents for 870599
Page 44: ...42 ...
