MANUAL
- Read the safety instructions carefully and follow the advice.
- Keep these instructions in case you need them later.
SAFETY
- To prevent electric shock, never open the light.
- Do not expose to rain, humidity, any liquids or heat.
- Never use in an area where flammable gasses or liquids are stored.
- IP20: Not designed to be left outside permanently.
- Only use the supplied USB cable to charge the light. Discarded electrical equipment must not be put
in the household waste. If possible, take it to a recycling company.
- This product contains a Bluetooth receiver and transmitter operating at 2.4GHz.
- This product contains a battery pack which cannot be replaced.
We can always be contacted for questions, service, complaints or other issues.
Send an email to [email protected] and we’ll get back to you.
BEFORE FIRST USE, CHARGE THE BATTERY FOR 4-6 HOURS.
Charge the lamp with the provided USB cable, which is compatible with any computer or cell phone
5 Volt output charger. Connect the USB cable to the computer USB port or connect to a cell phone
USB charger (fig. 2). A red LED will illuminate when charging the lamp (fig. 2F). The LED will switch off
once the battery is fully charged.
In order to maximise the life of rechargeable batteries, it’s essential to charge them regularly (we
advise once every 3 months). A completely empty or full rechargeable battery can become damaged
if not charged or discharged. Rechargeable batteries must be charged using a suitable standard 5VDC
charger. Any other voltage or a poor quality charger may damage the rechargeable batteries.
Once the battery is fully charged, the lamp will work for maximum 4 hours on the maximum setting
(“warm white” mode). The loudspeaker will also work for at least 6,5 hours, at 70% of the maximum
volume.
OPERATION
General (fig. 2)
A. Switching the lamp on and off. When switched on, the lamp will be activated in warm white mode.
Bluetooth is also automatically activated, you will hear “Bluetooth mode”. When switching it off, you
will hear a beep. The complete device is switched off.
B. Press this button briefly to play the following number on the micro SD card or in your YouTube or
Spotify play list. Hold this button in longer to increase the music volume.
C. Playing and pausing music. When using this device as a speaker to receive telephone conversations,
this button can be used to start and finish telephone conversations.
D. Press this button briefly to play the previous number on the micro SD card or in your YouTube or
Spotify play list. Hold this button in longer to decrease the music volume.
E. Press this button briefly to activate or deactivate Bluetooth. If Bluetooth is switched off, only the
lighting is active, you will hear “lighting”.
F. Charging indicator (red LED).
LIGHTING (fig. 2)
When the lamp is switched on (A), the light which is automatically in “warm white” mode, is out.
The lighting setting can be adjusted by touching the lamp speaker with your finger (fig. 2).
EN
Summary of Contents for DISC
Page 3: ......
