merchandise. If inspection discloses a defect, SMK will
either repair or replace the product with like equipment at
SMK’s expense. If no defect is found during the
inspection, or if the defect resulted from causes not within
the scope of SMK’s limited warranty, then the user must
assume all costs incurred returning and/or storing the
product.
All products and parts will be tested using SMK testing
criteria. Units found to be damaged, altered or otherwise
mistreated will not be covered under this warranty. Units
found not to be defective are subject to charges to be paid
by the returnee.
Page 5
Operating the Sprayer
Keeping all safety and operating measures in mind you are
now ready to begin spraying.
4. Prime the Sprayer
a. Squeeze the Spray Gun Handle
b. Turn the Power Switch On (depress white square)
c. The Pump is self priming and should begin spraying
in a few seconds.
d. IMPORTANT - When Power Switch Light starts
flickering (pump is cycling on and off), turn the
Speed Control down (counterclockwise) until the
light is steady on (pump is not cycling on and off).
e. After liquid is flowing and all air is purged from the
lines, release the Handle and the Sprayer will turn
off.
f. If the pump does not prime within 20 seconds, turn
off the power and check to see that all fittings are
tight and the Intake Filter is not clogged.
g. Running the Pump dry over 1 minute will destroy the
gears and void the warranty.
The pump is designed for continuous duty when proper
operating criteria are met.
!
C A U T I O N
!
BEFORE REMOVING THE SPRAY HOSE, TURN THE
POWER OFF AND RELIEVE ANY PRESSURE IN THE
SPRAY HOSE BY SQUEEZING THE SPRAY HANDLE.
Page 10
Assembly (Cont)
5. Set the Sprayer unit on top of the container by guiding
the inlet tube into the hole in top of container.
6. Set the Power Switch to the off position
7. Insert the Battery into the receptacle, DO NOT FORCE.
When properly aligned it will slide in easily. When fully
inserted it will contact the Sprayer housing and you will
hear a click indicating the Safety Switch has been
activated.
8. Check the sprayer trigger handle to make sure the
lever is not locked in the open/ on position.