Page 8 of 9
6/3/09 Rev 1 (DP)
22. Starting on the driver side, place adhesive
backed rubber gaskets between the body
and the Short Bottom Brackets,
(Figure 18).
23. With assistance, re-install the rear
assembly of the Roof Rack to the Side
Rails. Line up the holes in the Bottom
Bracket to previously drilled holes,
(Figure 18).
24. Insert (2) 8mm x 35mm Hex Head Bolts with (2) 8mm
Flat Washers through the Short Bottom Brackets and
body. Access the hardware through the opening for
the taillight and position the 2-hole Metal Plates over
the already inserted 8mm Hex Bolts, (Figure 19).
25. Secure the Metal Plates using the included (2) 8mm
Flat Washers and (2) 8mm Nylon Lock Nuts,
(Figure 19).
26. Repeat Steps 21-25 for the passenger side
installation.
27. Go to steps 13-14 to attach the Basket Holder Cross Rails.
28. Align Roof Rack properly and tighten all hardware.
29. IMPORTANT: Do periodic inspections to the installation to make sure all hardware is secure
and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
Fig 18
Fig 19
8mm x 35mm Hex Bolt
(2) 8mm x 35mm Hex Bolts
(4) 8mm Flat Washers
(2) 8mm Nylon Lock nuts
