Page 5 of 9
6/3/09 Rev 1 (DP)
Fig 8
Fig 9
Fig 10
Fig 11
8. On a clean, stable work area, assemble the
rear section of the Roof Rack by attaching
both Upper Rear Legs to the Rear Cross Bar.
NOTE: The Rear Cross Bar can be installed
with the light tabs facing forward (preferred)
or rearward (optional). Secure this assembly
by using the included (2) 8mm x 65mm Allen
Bolts, (4) 8mm Flat Washers and (2) 8mm
Nylon Lock Nuts, (Figure 8). Do not tighten
hardware at this time.
9. With assistance, attach the assembled rear
top section of the Roof Rack to the already
inserted Side Rails. NOTE: Be careful not to
damage the vehicle when attaching the top
section. Use the included (2) 8mm x 65mm
Allen Bolts, (4) 8mm Flat Washers and (2)
8mm Nylon Lock Nuts to attach the Rear Top
Legs to the Side Rails, (Figure 9 & 10).
10. For "Bolt Direct to Body" installation, proceed
to Step 18.
11. With assistance, hold the rear section of the
Roof Rack up and attach the Rear Bottom Leg
section to the Rear Top Leg section using the
included (2) 8mm x 65mm Allen Bolts, (4) 8mm
Flat Washers and (2) 8mm Nylon Lock Nuts,
(Figure 11). IMPORTANT! Do not lay Roof
Rack on your vehicle to attach the Rear Bottom
Legs at any time. Damage to the vehicle may
occur.
(2) 8mm x 65mm Allen
Bolts
(4) 8mm Flat Washers
(2) 8mm Nylon Lock Nuts
(2) 8mm x 65mm Allen Bolts
(4) 8mm Flat Washers
(2) 8mm Nylon Lock Nuts
IMPORTANT! Do not lay Roof
Rack on your vehicle to attach the
Rear Bottom Legs at any time.
Damage to the vehicle may occur.
3pc. Rear Section
4-Door installation is pictured as an
example. 2 and 4-Door Rock Crawler
Roof Rack installation is identical
