Page 3 of 9
6/3/09 Rev 1 (DP)
Fig 2
Fig 3
DO NOT TIGHTEN HARDWARE UNTIL ASSEMBLY IS FINISHED
PROCEDURE:
1. Peel, stick and trim the self sticking Foam Gaskets
to the inside surface of the two mounting tabs on
each Front Leg. Remove the driver side (4) factory
outer windshield hinge bolts. Locate the driver side
Front Leg, (A) and attach it to the windshield hinge
using (4) 8-1.25mm x 35mm Hex Bolts, (4) 8mm
Lock Washers and (4) 8mm x 24mm OD x 2mm
Thick Flat Washers, (Figure 1).
2. Slide front Cross Bar into partially installed driver
side Front Leg and secure it with the included (1)
8mm x 65mm Allen Bolt, (2) 8mm Flat Washers
and (1) 8mm Nylon Lock Nut, (Figure 2).
3. Remove the passenger side (4) factory outer
windshield hinge bolts. Locate the passenger side
Front Leg, (B) and apply the Foam Gasket as
described in Step 1. Align the holes on the lower
section of the Front Leg with holes on the
windshield hinge and slide the tube into the Cross
Bar. Secure the Front Leg to the vehicle using (4)
8-1.25mm x 35mm Hex Bolts, (4) 8mm Lock
Washers and (4) 8mm x 24mm OD x 2mm Thick
Flat Washers. Proceed to secure upper section of
the Front Leg to Front Cross Bar using the
included (1) 8mm x 65mm Allen Bolt, (2) 8mm Flat
Washers and (1) 8mm Nylon Lock Nut, (Figure 3).
4. Remove the two bolts holding the aftermarket
bumper-if equipped, (Figure 4).
DO NOT TIGHTEN HARDWARE UNTIL ASSEMBLY IS FINISHED
Fig 1
Fig 4
Apply foam tape to the back of
these mounting tabs to protect
vehicle's finish.
Cross Bar pictured with tabs
facing forward (optional).
Recommended install is with
tabs facing to the rear.
(4) 8mm x 35mm
Hex Bolts
(4) 8mm Thick
Flat Washers
(4) 8mm Lock
Washers
