6. Remove the drawbar.
7. Extend the mill spindle to expose the outer taper drift slot.
8. Rotate the spindle to align outer and inner taper drift slots. You will be able
to see the end of the adapter through both slots.
9. Insert the drift in the slot.
10. Holding the adapter with one hand, use a non marring hammer (rubber,
dead-blow, or brass) to drive the drift into the slot. The taper on the tool will
release and the adapter drop out.
Cutters mounted in the spindle must fit accurately. There are two ways to
make sure they do. For small cutters, fit the shank of the arbor that carries
the cutter directly into the taper hole at the end of the spindle. A drawbar
holds the arbor in place. For large cutters, bolt the cutter directly to the end
of the spindle.
Ordering Machining Accessories:
To order machining accessories for
your MI-329M mill refer to the accessories section of the Smithy website at
www.smithy.com
.
29
Summary of Contents for MI-329M
Page 1: ...Smithy MI 329M Operator s Manual 1 ...
Page 30: ...Chapter 13 Diagrams and Parts Listings 30 ...
Page 33: ...33 ...
Page 37: ...37 ...
