Smithy MI-329M, Operator'S Manual

Page: 20 / 39

Chapter 7
Preparing the MI-329M for Operation
Overview
Before using your new machine, it is important to make sure it is top working
condition and is properly lubricated. The section of the manual, will walk you
through lubrication and gib adjustments.
Cleaning and lubricating the machine
Smithy machines are shipped with a protective grease coating. To remove it,
spray on WD-40, let it sit for a few minutes, and wipe it off with rags. Use a
brush and noncorrosive kerosene or white mineral spirits to clean hard to
reach places.
Give special attention to the lead screw. Use a brush or cotton string to clean
down into the threads.
Once it's cleaned, your Smithy is ready for lubricating. Do this carefully and
thoroughly before starting the machine. There are oil buttons located in
numerous locations on the machine. Use pressure oil can and good quality
SAE No. 20 or 30 weight machine oil.
The mill head has an oil site gauges on the right side of the mill head. The
oil level should be half way up the site gauge. SAE 30 oil is recommended for
the headstock. The oil is added through the vent plug on the top of the mill
head.
When the machine is not in use, it is recommended that a thin coat of oil be
applied to all exposed metal parts to protect the surfaces from corrosion.
20