Z Axis Gib Adjustment
Images below will show the location of the adjustment screw. The process is
also the same with the X and Y axis gib adjustment. Screw out the upper
screw and screw in the lower screw will loosen the gib while screw in the
upper screw and screw out the lower screw will tighten the gib.
Chapter 8
Running-in
The MI-329M milling machine is put through a initial run-in procedure at the
factory before the machine is packaged for shipment.
1.
Once you have your mill setup, Smithy recommends that the spindle
motor be run for about 5 minutes at each of the spindle speeds
starting with the slowest speed.
2.
When the machine has set for some period of thin without being run or
if the machine is in a cold environment, it is recommended to run the
spindle for about 5 minutes at a medium speed before beginning and
cutting operations.
22
Summary of Contents for MI-329M
Page 1: ...Smithy MI 329M Operator s Manual 1 ...
Page 30: ...Chapter 13 Diagrams and Parts Listings 30 ...
Page 33: ...33 ...
Page 37: ...37 ...
