INTRODUCTION
In the event of items missing or visible damage please contact us on 01245 324560.
This heating appliance is intended for mounting on a wall at low level. The minimum
recommended installation height is 150cm (6 inches) from the floor. There is no
clearance required on either side of the heater.
This heater must not be used in bathrooms or other high humidity areas.
Ecovector™ is designed for use on standard two-pipe pumped central heating
systems where the system hot water is generated from either a boiler or renewable
sources. This product is not suitable for one-pipe heating systems.
Pipe connections
are 15mm.
We recommend the use of full flow isolating valves. These valves should be
accessible after completion of the installation.
Ecovector™ is classified as a fixed appliance and electrical connection should be via
a double pole 3A fused spur. The fused spur must not be directly above the heater
but should be accessible after completion of the installation. If the pre-wired mains
cable is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons. The appliance must be earthed.
To avoid possibility of vibration, this product must be installed on a flat, even surface.
To comply with Building Regulations Part L (Part J in Scotland) this heater is fitted
and controlled by an integral room thermostat
Please note the guarantee may be invalidated if this product is not installed
and used in accordance with this guide.
MOUNTING THE UNIT
Remove the EZ hanger from the back of the heater. Remove screws from the
underside of the front panel, carefully lift up and remove
.
2
Ecovector™ includes a selectable low temperature thermostat that prevents the
fan(s) operating until the central heating system water passing through the heat
exchanger reaches a set temperature.
Heating
Ensure your central heating is ON, the heat output switch set to Low (I) and the
thermostat set to the required position (position 3 is approximately 20°C).
If you require a faster warm up set the heat output switch to High (II)
7
For latest prices and delivery to your door visit MyTub Ltd - www.mytub.co.uk - [email protected] 0844 556 1818
