Smithco SWEEP STAR P48HE, Parts And Service

Page: 9 / 40

7
Service
OPERATION
STOPPING THE ENGINE
.1 Do not move choke control to CHOKE position to stop engine. Backfire or engine damage may occur.
2. Move Throttle control to idle or SLOW position. Then turn key to off position.
3. Close fuel shut off valve.
4. Always remove key from the switch when equipment is not in use or left unattended.
MAINTENANCE
Before servicing or making adjustments to machine, stop engine on tow vehicle and remove
key from ignition.
Use all procedures and parts prescribed by the manufacturer's. Read the engine manual
before operation.
LUBRICATION
Use No. 2 General Purpose Lithium Base Grease and
lubricate DAILY. The Sweep Star P48 High Dump has 6
grease fittings. The Sweep Star P48 Low Dump has 4
grease fittings. All bearings are sealed bearings. When
inserting grease, be careful not to ruin the seal, if this
happens, replace the bearing at once. Be sure to wipe
grease fitting clean before injecting grease. Give only one
or two pumps of grease at each lubrication. Apply grease
to bottom inner surface of hitch box to prevent binding.
Ref#Location
1 Two on inside frame pivot tube. (High Dump)
2 Two on hopper sub frame pivot tube. (High Dump)
3 Two on the hitch lock pin by the coil spring. (Common)
4 Two on each side on rod end. (Low Dump)