Smithco SWEEP STAR P48HE, Parts And Service

Page: 6 / 40

4
Introduction
SETUP
The Sweep Star P48 arrives from with some setup required.
1. The tongue and wheel will need to be installed.
2. You will need a tow vehicle to move the Sweep Star P48. The Sweep Star P48 has a Clevis Hitch that will need a
3
/
4
diameter by 4" pin with some type of lock.
3. Remove tires from pallet. Tires are banded so take caution when cutting bands. Place tires on axle.
4. Remove tongue from pallet. Install the tongue and place jack in upright position.
5. Crank the jack up so you can hook to tow vehicle.
6. Check the tire pressure. 18 psi (1.3 bar).
7. Check hydraulic fluid level in tank on tow vehicle.
8. Machine should be greased before starting. See Maintenance part of manual.
9. Read operating instructions before starting.
OPERATION
Before operating this machine, become familiar with all controls and functions of this unit and the tow vehicle.
Also complete all maintenance requirements and read all safety warnings. By knowing both machines thor-
oughly, how it operates and by doing the prescribed maintenance steps, you can expect relatively trouble-free
operation for years to come.
TOW VEHICLE
You will need a heavy duty vehicle with 4 wheel brakes with a clevis hitch and a
3
/
4
diameter by 4" pin with
some type of lock.
DAILY CHECKLIST
1. Check engine oil level in tow vehicle. Add as needed. DO NOT OVERFILL.
2. Tire pressure should be 18 psi (1.3 bar) on Sweep Star P48
3. Check hardware for loose or missing nuts, bolts, screws, etc., and tighten or replace as needed.
4. Inspect hydraulic lines for damage or leaks. Never use hands to inspect leaks.
5. Check hydraulic fluid level in tank on tow vehicle.
6. Check controls for smooth, proper working operation. Lubricate as needed.
7. Check and clean all debris from reel housing.
OPERATION SAFETY
1. Before operation check to see that brush reel is rotating properly.
2. To began sweeping, lower sweeper head. Check to see that hydraulic lever is in low flow on Cushman
Truckster.
3. Make sure towing vehicle is moving when you turn on brush.
4. Travel slow enough to ensure complete material pickup. If sweeper is not sweeping clean you will need to
slow down your travel speed.
5. If possible try not to make sharp turns with the sweeper head on the ground.
6. When working on greens, began at the edge and work inward.
7. Do not make sharp turns on inclines, as tongue could contact rear tires of tow vehicle causing the tow
vehicle to overturn.
8. Do not stop the tow vehicle and let the brush run or damage to turf may result.
9. Sweeper will not pick up material properly if material is to wet.