Smithco 45-204, Parts & Service

Page: 91 / 161

B-33
Center Attachment
45-195 GRADER BLADE PARTS LIST
REF# PART# DESCRIPTION QTY
1 42-207 Grader Blade 1
2 HHP-18 Bridge Pin, 1 /
8
2
3 HB-38-16-125 Hex Bolt, 3 /
8
- 16 x 1 1 /
4
4
HW-38 Flat Washer, 3 /
8
4
4 45-190 Blade Mount 1
5 HB-716-14-150 Hex Bolt, 7 /
16
- 14 x 1 1 /
2
4
HNTL-716-14 Nylon Lock Nut, 7 /
16
- 14 4
HW-716 Flat Washer, 7 /
16
4
6 45-191 LH Carrier Bracket 1
7 45-192 RH Carrier Bracket 1
45-195 GRADER BLADE INSTALLATION INSTRUCTIONS
1. Lower center attachment to the ground and remove the 3 Clevis Pins (Ref. B) .
2. Remove the (4) hex bolts holding each of Blades (Ref A) to the right and left of the center blade. Set the
Blades and (4) Lock Nuts aside.
3. Place the Blade Mount (Ref. 4) on top of the attachment frame, lining up the slots where the bolts were
removed. Replace the removed bolts with the included
3
/
8
-16 x 1
1
/
4
Hex Bolts and
3
/
8
Flat Washers (Ref 3) .
Reinstall the Blades (Ref. A) and secure using the
3
/
8
-16 Lock Nuts that were set aside.
4. Check all hardware for tightness.
5. Reinstall center attachment. Slide the Grader Blade (Ref. 1) onto the pins, as illustrated, and secure using
the Bridge Pins (Ref 2) .
6a. To install the Carrier Brackets on a machine without a roll bar :
Mount the RH Carrier Bracket (Ref. 7) and LH Carrier Bracket (Ref. 6) to the to the ROPS towers using the
inside set of holes. Secure each Bracket using the 7 /
16
-14 x 1 1 /
2
Hex Bolts, 7 /
16
Flat Washers and
7 /
16
-14 Lock Nuts.
6b. To install the Carrier Brackets on a machine with a roll bar :
Remove the (4) inside bolts, position each Carrier Bracket (Refs. 6 & 7) over the holes and use the
7 /
16
-14 x 1 1 /
2
Hex Bolts, 7 /
16
Flat Washers and 7 /
16
-14 Lock Nuts to secure.
7. When placing the Grader Blade in the Carriers point the mounting tabs downward as shown in the photo
below.