Smith SPS10, Operation - Repair - Parts

Page: 16 / 68

Operation
16 3A5578D
Cutting Material
Before substrate removal, test run the drum with cutters
not touching the surface. If there is excessive vibration,
you need to re-balance the cutter set-up, check bearing
condition, and/or make sure that the Drum Access Panel
is secured.
1. Start Engine , see page 15.
2. Turn vacuum on, if using a vacuum.
3. Connect Engine Kill Button Cord to operator.
4. Slide Engine Throttle to desired
setting.
5. FS Series Models - Disengage Drum Engage Lever
and adjust to position where drum is almost
touching the ground.
SPS Series Models ( Non-DCS Models Only):
Lower the Drum Engage Lever into the down
position.
6. Non-DCS Models: Rotate Drum Adjustment Dial
until drum comes into contact with surface and
desired depth is reached.
Maintain a safe operating distance from other people
in the work area. Avoid any pipes, columns, openings,
or any other objects protruding from your work sur-
face.