SMITH Manufacturing 1-954-941-9744 www.SmithMfg.com
SMITH Manufacturing 1-954-941-9744 www.SmithMfg.com
VERSION 11/2016
FS351SP
Propane
5
HanDle BaR aDjUStMent
The handlebars are equipped with a high-density
vibration suppression material to minimize
operator fatigue and increase comfort level when
operating equipment. To adjust the handlebars
to a new position for different height operators
please follow these steps:
• Using a wrench or socket (9/16”), loosen
the bolts on both sides of the handlebars
two to three turns only.
• Adjust handlebar to desired position and
re-tighten the 4 screws
never operate with handlebars loose.
the bolts must be fastened tightly assuring
the handle is locked into position.
Loosen to
adjust
HyDRoStatIc oPeRatIon
Check to insure the hydrostatic drive system
is in neutral. The control lever should be in the
middle position and the wheels should not be
turning. Lower the unit by moving the Cutter
Height Adjustment T-Handle into position. This
will raise the carriage wheels off the ground and
set the unit onto the drive wheels. At this point
the unit can be propelled forward or in reverse
by moving the drive lever either forward or
backward. The Fine-Adjustment Knob may be
used to make small corrections in height. The
“live” axle will tend to move the unit in a straight
line, however both hands are required on the
handle for safe operation and minor directional
corrections. For more aggressive directional
changes or repositioning requirements, simply
reengage the lift carriage by using the Height
Adjustment T-Handle.
RUn SPeeD for Diamond cutters is wide
open (3200 rpm) .
the Max RUn SPeeD for Drums is 1100 rpm
(lower may be used).
Engine must be warmed up and at RUN SPEED.
Height Adjustment
T-Handle
Control Lever
Fine Adjustment
Knob
