SMITH Manufacturing 1-954-941-9744 www.SmithMfg.com
FS351SP
VERSION 11/2016
Propane
12
SMITH Manufacturing 1-954-941-9744 www.SmithMfg.com
DRUM RePlaceMent cont’D.
your drum may be equipped with the newly
revised drum retention design. this can
be identified by the three (3) set-screws
on either side of the of the drum, and the
notch cut out from the Bearing Housing.
To remove this type of drum, you will first
need to remove the set-screws.
Before beginning servicing on any
propane-powered unit,
DISconnect SPaRK PlUg WIReS!
1.) after making sure that the engine is
off and either disconnecting the battery
or removing the spark-plug wires, rotate
the drum so that the first set-screw on
the side of the drive-belt lines up with the
notch in the Bearing Housing. If the drum
is too difficult to rotate, you may need to
loosen the drive-belt. Refer to Pg. 13 for
instructions on loosening the drive-belt.
1)
3.) Remove the Sideplate, as described on
Pg. 11.
4.) you now have access to remove the
remaining three (3) set-screws on the other
side of the drum.
5.) once all six (6) set-screws have been
removed, you are now able to slide out and
remove the drum as described on Pg. 11.
6.) to replace the drum, slide it onto the
shaft, then secure the six (6) set-screws in
the same way they were removed.
3)
4)
2.) Once the first set-screw is removed,
rotate the drum to remove the remaining
set-screws in the same way.
